fbpx

30 : How to install the HorseGuard Bi-Polar fencing

   

cat2010_2901

 

A mile of tape… … is easy to pull.

 

cat2010_2902

 

Tensioner #BP32
for connection posts

(To connect all the tape raws to your charger)

cat3707-copie

New tensioner #BP37

(To connect and tension all the tape raws to your charger)

TIP to install round black Clips  (#RCLIPbl) :
A pre-hole done with a screw driver make the clip installation easy and fast.

 

#45V Corner Insulator for wooden post

#45V Corner Insulator for wooden post – For a maximum distance of 160 ft between 2 tension posts.
sold with 2 clips and 2 lag bolts.

Third buckle for three way on #BP37

New Spring kit #BP38 for gate

bp38bp13a

New Spring kit #BP38 for gate : installation of a gate with elasticity
with the same tape as your fence, with the tape of the spool.

Gate handle for tensioner BP32 or BP37

three Horseguard Gate Handles

Gate with springs and Bi-Polar tape

# BP38_ + #BP13A

Gate Handle #BP12A for #9bl block tensioner (tensioner block #9bl is not sold anymore).


Poignée de porte Bi-Polaire #BP12A

I – Measure and draw a mark

Measure and draw a mark for the placement of the middle tape, report the same mark on all posts…

… to install block tensioners and insulators at the same level..

On line posts, secure all insulators with 2 wood screws. Do not insert the thumbscrew yet the tape will be set at the very end of the installation.

II – On the “Control Tower” post

bp37surbois-1

 

On the Control Tower post, position the HorseGuard Tensioner on the mark and drill in just one lag bolt to hold it in place.

#CRIMP59

 

Printable instructions (PDF)